Unable to program Remote System Upgrade over UART based on NiosII Processor with EPCQ(cyclonev dev )

[manishkumar]

unable to program:

Remote System Upgrade over UART based on Nios
II Processor with EPCQ (Cyclone V E FPGA
Development Kit) design example to CycloneV E FPGA Dev kit.

shown errors while programming files through Quartus prime programmer: Can't recognize silicon id for device1. A device's silicon ID is different from its JTAG ID: VERIFY THAT ALL CABLES ARE SECURELY CONNECTED

[Farabi]

Hello,

This case is duplicated with case 06207132. I will close this case and continue to support you on case 06207132.

regards,

Farabi