- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am doing filtering of a signal.
i am using mega core library,nco compiler and fir filter block.i specified the parameters and generated the blocks in simulink, but i am not able to generate the specified output on the scope.i am geting no output on the scope. another problem is that i am using signal tap analysis in this design.i am not familiar with that block how to use it. please help me.Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What kit (if any) are you using?
Did you select the Development Board in the Simulink / Altera Signal Compiler? Mike- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
DSP development kit,cyclone 2 edition.
yes i selected the development board in the simulink/altera signal compiler.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
First thing to check is the .PIN file generated by the Signal Compiler / QuartusII. Verify that the pin-out is correct. That has been a large problem with the DSP Builder / QuartusII setup.
If the pins are correct, try something much smaller using the QuartusII only environment; to ensure you have a good build setup. Mike
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page