https://www.intel.com/content/www/us/en/support/programmable/articles/000076366.html?wapkw=calibrati

[Sap]

https://www.intel.com/content/www/us/en/support/programmable/articles/000076366.html?wapkw=calibration fail : seq c

As above link suggests:

I am using Quartus prime v16.1 to program a .bin image file and the error is not resolved.  Can anyone help?

[JingyangTeh]

Hi Sap

May I ask if you are using one of the devkit or you are using a custom board?

If you are using a custom board, have you change the memory size in the device tree to match with the Quartus project?

Regards

Jingyang, Teh

[Sap]

'If you are using a custom board, have you change the memory size in the device tree to match with the Quartus project?'

Hi Jingyang,

Thank you for your reponse. It's a custom board.  What do you mean by 'change the memory size in the device tree', do you have a screen shot to show?

I am using an altera programmer to program a custom .bin file into a custom board using Nios2 command shell

[JingyangTeh]

Hi

If you are using a custom board you could not use the GSRD that is available.

You would need to change the quartus project emif parameter and the device tree below:

https://github.com/altera-opensource/u-boot-socfpga/blob/ff416d887f993e0b0cd2f14cb2fb6b486ad6682f/arch/arm/dts/socfpga_cyclone5_sockit.dts#L6

Line 17 to 20

Regards

Jingyang, Teh

[JingyangTeh]

Hi

Since there are no feedback for this thread, I shall set this thread to close pending. Please login to ‘https://supporttickets.intel.com’, view details of the desire request, and post a feed/response within the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. The community users will be able to help you on your follow-up questions.

If you happened to close this thread you might receive a survey. If you think you would rank your support experience less than 4 out of 10, please allow me to correct it before closing or if the problem can’t be corrected, please let me know the cause so that I may improve your future service experience.

Regards

Jingyang, Teh