QGC Error: NO MAG SENSOR 0; NO GPS Signal; Sensors Cannot Be Calibrated.

[RobinX]

Hi, I just got a brand new Intel Aero RTF, and here is the information.

BIOS_VERSION = Aero-01.00.16

OS_VERSION = Ubuntu 16.04.5 LTS"

AIRMAP_VERSION = unknown

FPGA_VERSION = 0xc2

AeroFC firmware version = 1.6.5

After I connect the QGC to the RTF, the QGC shows me that "PREFLIGHT FAIL: NO MAG SENSOR 0". And also I cannot get any GPS information and battery information from the drone.

When I tried to calibrate Level Horizon sensor, I got following errors:

attitude estimator not running - check system boo

[cal] calibration failed: level

And also, the Compass sensor cannot be calibrated.

I am hoping that there is nothing wrong with the hardware. But I don't really know what I can do next. I really appreciate if anyone can provide some help.

[Alexandra_C_Intel]

Hi RobinX, Thank you for your interest in the Intel Aero drone. Could you do an Airframe reset and calibrate the sensors again? https://github.com/intel-aero/meta-intel-aero/wiki/02-Initial-setup#calibration-1 Let me know if the problem persists. Regards, Alexandra

[Alexandra_C_Intel]

Hi RobinX, Did you manage to do the calibration again? Regards, Alexandra