- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
When trying to use the make command to compile using a Makefile I keep getting an Error 127 " opt/intel/oneapi/mpi/2021.2.0//bin/mpiifort: line 695: ifort: command not found.
I followed the installation guide and ran the "run a sample project" successfully. I already took a look at previous comments about a similar issue but it didn't solve the error.
Any help would be highly appreciated.
Thanks
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Thanks for reaching out to us.
Could you please provide the system environment details?
Please make sure you run the setvars.sh/setvars.bat file before running the makefile and share with us the complete error log.
Could you also please provide the reproducer code so that we can investigate more on your issue?
Thanks & Regards
Shivani
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
As we didn't hear back from you, Is your issue resolved? If not, please provide the details that have been asked in my previous post.
Thanks & Regards,
Shivani
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
As we have not heard back from you, we are considering that your issue has been resolved and we have answered all your queries. So we will no longer respond to this thread. If you require additional assistance from Intel, please start a new thread. Any further interaction in this thread will be considered community only.
Have a Good day!
Thanks & Regards
Shivani
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page