- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i am trying to Instantiate Transceiver 'Custom PHY v17.1' IP in Platform Designer Tool. The IP is available in IP catalog at Quartus Prime Tool's view. But not seen inside IP catlog of Platform Designer's view. Any advice would be helpful. I am using Quartus Prime Lite Edition 17.1 for Cyclone V SX SoC device
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi AMath1,
For your information, your observation is expected. This is because the Custom PHY is not formally supported in the Platform Designer Tool. Generally it is recommended to instantiate the Custom PHY in RTL/block diagram using IP Catalog in QPrime Tools. Then connect to the Platform Design generated module at the top level file.
Thank you.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi AMath1,
For your information, your observation is expected. This is because the Custom PHY is not formally supported in the Platform Designer Tool. Generally it is recommended to instantiate the Custom PHY in RTL/block diagram using IP Catalog in QPrime Tools. Then connect to the Platform Design generated module at the top level file.
Thank you.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page