Problems to program Cyclone V GT FPGA

[Altera_Forum]

Im new using Altera boards I have two questions. 

I check the Quartus_II_Introduction for verilog users. On the programming chapter it says that "DE0-CV, DE0-Nano and DE2-115 Boards" should have a RUN/PROG switch.  1.-Does the cyclone V GT FPGA board has such switch? 2.-Also where can I find the pin assignments for this board?  Thank you

[Altera_Forum]

Did you notice the Cyclone V GT DevKit Reference Manual? 

 Best way to get the pin assignments is to import a reference design shipped with the board.

[Altera_Forum]

Hi, 

 1.We dont have such switch but take care SW4.4 and SW5 setting for programming. For more information you can refer user guide https://www.altera.com/en_us/pdfs/literature/ug/ug_cvgt_fpga_dev_kit.pdf 2.For pin related information,use reference guide https://www.altera.com/en_us/pdfs/literature/manual/rm_cvgt_fpga_dev_board.pdf  Best Regards, Anand Raj Shankar (This message was posted on behalf of Intel Corporation)

[Altera_Forum]

Thank you FvM and Anand Raj Shankar 

 I was able to get the pin Assignment by searching a bit more on internet.  As for the programming the FPGA I still have some problems, here is what I do:  SW1, SW3, SW4 default configuration SW4: Also I tried Factory user = off SW5 I tried with default configuration SW5 I tried with MSEL1 0 and 1  To activate Active Serial MSEL 0 and MSEL 1 should be 0 , 0 according to 13. Configuring Cyclone FPGAs (Cyclone Handbook Volume 1 chapter 13)   *Quartus Prime Lite Edition Software Load project Assigments->Device->Device and Pin Options  Configuration scheme: Active serial 1x  Configuration device Auto Compile  File->Converting Programming File Programming file type: JTAG indirect configuration file *.jic Configuration device: EPCQ128A/EPCS128 Flash loader->Add device: Cyclone V / 5CGTFD9E5 SOF Data->Add file: File.sof Generate  *Quartus Prime Programmer Lite Edition Software Autodetect 5CGTFD9E5 Select 5CGTFD9E5 click change file select file.jic Check Program/Configure checkbox Start  Operation failed  The error I got is  Error (209025): Can't recognize silicon ID for device 1. A device's silicon ID is different from its JTAG ID. Verify that all cables are securely connected, select a different device, or check the power on the target system. Make sure the device pins are connected and configured correctly.  Error (209012): Operation failed