Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12652 Discussions

Can I start Modelsim/Questa GUI when I am using command line mode?

Altera_Forum
Honored Contributor II
‎06-04-2015 08:42 PM
2,268 Views

When I do simulation, ususally I will start with command line mode, to save some resource (I also hear it may accelerate the simulation). But after simulation done, sometimes I want to open the GUI to have a look, to check such as whether the simulation duration is enough. So I wonder whether I can open GUI when I am using command line mode? If I can, how? 

 

Thank you in advance.
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎06-04-2015 09:47 PM
1,355 Views

I don't know how to link to a running simulation, you can definitely start up another instance. 

 

What I've done in the past, is started the sim that dumps to a wlf file, then open that file in another instance. This works with modelsim. Haven't tested with Questa. 

 

To keep the GUI from pulling another simulator license, i start it with the -lic_no_lnl option. This way it only pulls the gui waveform viewer. 

 

Pete
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.