Cyclone III Starter Kit: No CFI table found

Nios® V/II Embedded Design Suite (EDS)

Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++

Cyclone III Starter Kit: No CFI table found

929 Views

Hi,

I started a project with an altera dev-board (Cyclone III FPGA Starter Kit) a few weeks ago. I want to access the external flash (Intel 128P30) via JTAG, thus do read/write operations. I was building up a Nios II system to reach my goal.

A screenshot of my system is attached.

First I tried to programm my flash with Flash Programmer GUI. After this failed I tried to use the command shell. But I still get the same error: "No CFI table found at address 0x01000000" (look at screenshot). I looked at other threads but got no solution.

Did anybody have the same problem with this dev-board? Could please anybody help me analysing my problem? I have no idea where to look at.

Best regards.

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.