Development for ARM Using DS-5

Nios® V/II Embedded Design Suite (EDS)

Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++

Development for ARM Using DS-5

1,004 Views

Hi,

I am totally new to Embedded Systems and my mind is just blowing off trying to understand how should I start development with ARM.

I am using SoCKit by Altera which has FPGA as well as ARM unit. I have read a lot of documents about DS-5 and all seem to talk about porting Linux to the board and so on.

I want to run FFT on the ARM side of the device. Can someone tell me how can I use FFT algorithm provided by FFTW on this device ? Do I need to use DS-5 to compile the project and run on ARM ?

I appreciate your help.

Thanks.

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.