Getting an IP address

[ntahoturi5922]

Hello Everyone. 

I have been working on this project for a while now for school work. I am using a TSE IP with MSGDMA using edition 18.1. 

The system builds ok and says that it is running. But I am trying to get an IP address display on the nios ii console but it remains blank. 

I have included my system from platform designer, and what I get when I ran the system. 

If anyone could help, it would be greatly appreciated. 

Thanks in advance. 

SYSTEM FROM PLATFORM DESIGNERSYSTEM FROM PLATFORM DESIGNERI get nothing when i run the systembsp editor

[Paveetirra_Srie]

Hi Jacques,

Apologize for the delay. Just to confirm, Is the issue been resolved?

If no, I will look into it right away.

Regards,

Pavee

[ntahoturi5922]

Thank you for getting back to me. I have not resolved the issue. I suspect that I have an issue with the TSE MAC configuration. So, I am looking into that but no lock so far. 

[Paveetirra_Srie]

Hi Jacques,

You can check TSE MAC configuration through example design in AN647. I have attached the link for your reference.

Kindly download the example design and unarchive, there is a file called "config.tcl", this file contains the TSE MAC register setting. System console will source this file to configure the TSE MAC register.

https://www.intel.com/content/www/us/en/docs/programmable/683344/current/single-port-triple-speed-ethernet-and.html

Regards,

Pavee

[Paveetirra_Srie]

We do not receive any response from you to the previous reply that I have provided. This thread will be transitioned to community support. 

If you have a new question, feel free to open a new thread to get the support from Intel experts. 

Otherwise, the community users will continue to help you on this thread. 

Thank you.