Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12599 Discussions

Latency and corruption on ARM ethernet port

Altera_Forum
Honored Contributor II
1,039 Views

I'm sending an H264 stream out on the ethernet port of the ARM on my Cyclone V SOC chip. In general it sends fine, but occasionally there's a 'blip' and either packets get corrupted or paused for a while and then catch up. Equally, packets that are timed to be at an interval, and I make sure are inserted at 100ms intervals, are often reported as being >500ms apart. 

 

I can receive a stream in without issues, so am wondering why there would be any delay on sending a stream.  

 

If anyone has had similar issues sending video into/out of the ARM I'd be very interested to hear. 

 

Regards, 

Simon
0 Kudos
0 Replies
Reply