Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12666 Discussions

NiosII JTAG Debug - Hardware Triggers

Altera_Forum
Honored Contributor II
‎09-13-2017 12:33 PM
1,119 Views

Hi! 

 

In Altera's document "n2cpu_nii5v1.pdf", under JTAG Debug Module, there is section called "Hardware Triggers", page 2-21. 

 

Question 1) 

Can this feature be used for detecting if value on specific memory address is changed to some other specific value? (In doc. is mentioned that Trigger conditions on the same bus can be logically ANDed, so probably answer is yes but I need confirmation). 

 

Question 2) 

How to use this feature? Standard "watch" command from gdb can only monitor if there is read, write or read/write access to some specific memory address.. 

 

Thx!
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.