Saving a project to on board flash memory to boot on start up

Nios® V/II Embedded Design Suite (EDS)

Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++

Saving a project to on board flash memory to boot on start up

953 Views

Hi guys, im very new to this but learning.

Im have a project that works fine, but upon switching the board (DEO-Nano) off the program obviously disappears. I was told i can use the on board memory to save it there and upon powering up the board it will run.

Can someone please explain how is it done, i can seem to find anything useful online :/

Thanks in advance.

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.