Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12537 Discussions

nios on fpga not responding proper

Altera_Forum
Honored Contributor II
1,211 Views

Hi, 

I have built nios on fpga.Nios design includes clock source,nios,jtag,on-hip memory,PIO-connected to led.Then I did counter c program on eclipse.GETs 00-ff output on console window but led not blinking on board. I used led pin properly. 

 

I used in built eclipse binary count program.What is problem? 

 

please reply 

 

ThankYOU
0 Kudos
2 Replies
Altera_Forum
Honored Contributor II
192 Views

how are you writing to the PIO? 

 

it should be something like this: 

 

while(1) 

IOWR_ALTERA_AVALON_PIO_DATA(PIO_0_BASE, count&0xFF); //write a value to show Nios is alive 

count++; 

delayOneSecond(); 

 

 

you can check that you are writing to the correct address by running in debug mode and manually edit the memory location and see if the LEDs change.
0 Kudos
Altera_Forum
Honored Contributor II
192 Views

Hi, 

 

Actually I just used the inbuilt Binary count program template from eclipse. can u please check that? 

 

In that 4 switches are assigned to different peripherals. SW0 is set to blink led. while pressing sw0 I should get the led display .Right????  

 

else please help me in righting the simple program.
0 Kudos
Reply