- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi all,
i have a problem. on my 1c12 board i wanna use the mac without using the jtag. the mac only works after i start the terminal and the linux load up. it should work this way: reset -> access over telnet to the board. does anyone know a solution for my problem?? thx http://forum.niosforum.com/work2/style_emoticons/<#EMO_DIR#>/cool.gifLink Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When you use the JTAG UART, the kernel is susspended until you open a nios2-terminal.
Search the forum t, there are a few posts that tell you how to fix this problem by disabling the JTAG UART in the Kernel and then enabling/using the Serial UART. Hope this helps.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Look at this post for an example:
http://www.niosforum.com/forum/index.php?a...ct=st&f=2&t=589 (http://www.niosforum.com/forum/index.php?act=st&f=2&t=589)
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page