- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I was wondering how I could connect the GPIO-HSTC card on the max 10 development kit which has HSMC. I used it but the JTAG connection is lost by connecting it. In Digikey, there is another daughter's card (P0033) which is not available at the Terasic store.
Thanks,
Mohammad
Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Mohamad.
may I know which Max 10 development kit are you using?
Regards,
Aqid
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Aqid,
The Altera MAX 10 FPGA Development Kit is the one we have.
Thanks,
Mohammad
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
For the connection on the HSMC port, you can refer to the Max 10 Development kit Board Schematic. I share you the link below:
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page