How to connect a multiple channel ethernet and xaui interface on cyclone V ?

Programmable Devices

CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers

How to connect a multiple channel ethernet and xaui interface on cyclone V ?

532 Views

Hi,

So basically my system works with a xaui interface and 5 ethernet channels so if The count is right; 9 Transceivers are needed to make this design.

the cyclone V has 9 transceivers and compatible with XAUI (Soft PCS) but these transceivers are dispached on 3 GXB banks with triplets.

How can I connect them to the Transceiver reconfiguration controller knowing that XAUI is using 156.25 MHz and the ethernet channels use 125MHz.

Best Regards,

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.