- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We have an Icelake-D Xeon Microprocessor, installed on a router PCB.
I believe the part number is D-1700.
We are driving the TCLK input ( AH-51 ) using a TI CPU JTAG Translator 74AXC8T245 , with output voltage set to 1.01 volts. This pin on the microprocessor pulls the data line voltage (VOH) to 0.633 volts.
I am looking for the drive requirements for the TCLK input for this microprocessor.
-g
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Thank you for your recent inquiry. However, I would like to inform you that this forum page only supports FPGA-related products and not the Icelake-D Xeon Microprocessor products you are inquiring about.
I suggest posting your question on a forum page that supports the microprocessor. This will enable you to receive a more accurate and relevant response.
https://community.intel.com/t5/Embedded-Server/bd-p/emb-server-hardware-software-firmware
(I am not familiar with these products, and this is the closest forum page that I could find that is related to Intel Xeon)
Thank you for your understanding and cooperation. Please let me know if you have any further questions.
Best Regards,
Richard Tan
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page