Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20644 Discussions

What is the "Desired Reference clock frequency"? (fpll)

schlee68
Beginner
467 Views

Hi- Everybody

I tested a chip.

Test is data in put and then other chip any signal output.

 

It was successful up to 4G.

In higher frequency than 4G failed.

But in fPLL GUI, wrote the some value "Desired Reference clock frequency" 

i wrote the some value "Desired Reference clock frequency"

So, I was successful up to 4.8G.

for example, written frequency is below

schlee68_1-1675987836997.png

 

in data rate 4100, wrote 102.5MHz

in data rate 4200, wrote 105MHz

 

What is the meaning "Desired Reference clock frequency" ?

 

0 Kudos
1 Solution
IntelSupport
Community Manager
453 Views

Desired Reference clock frequency is a valid values for reference clock frequency and it change with the data rate but the reference input clock frequency must be within 50 MHz and 622 MHz. Range of supported reference clock frequency is dependent on device. You may device datasheet for range of supported frequency for every device.


View solution in original post

0 Kudos
3 Replies
IntelSupport
Community Manager
454 Views

Desired Reference clock frequency is a valid values for reference clock frequency and it change with the data rate but the reference input clock frequency must be within 50 MHz and 622 MHz. Range of supported reference clock frequency is dependent on device. You may device datasheet for range of supported frequency for every device.


0 Kudos
IntelSupport
Community Manager
433 Views

Let me know if there is any other concern at your end.

Otherwise I will put this ticket to close pending


p/s: If any answer from community or Intel support are helpful, please feel free to mark as solution, give Kudos and rate 5/5 survey



0 Kudos
Reply