- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I planning to connect up to 16 LED to MAX II CPLD (EPM240). 1. Are there any special consideration I should take? I.E. pins on the CPLD that I should use / or do not use? 2. Should I connect the LED in a "sink" or "source" mode? Thank you EitanLink Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Eitan,
http://www.altera.com/literature/an/an286.pdf (Application Note entitled "Implementing LED Drivers in MAX & MAX II Devices") answers your questions. Regards, --jmv- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you,
Eitan Barazani
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page