- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
http://forum.niosforum.com/work2/style_emoticons/<#EMO_DIR#>/ph34r.gif hello,
I did a niosii custom instructiont mode,and input it into my system via SOPC,but I ran into troublesome when I oprate the custom instructiont mode in NIOSII IDE. According to the Example B(p2-1,Bit-Swap Custom Instruction) of Software Interface of "Nios II Custom Istrucrion User Guide" ,the custom instruction used in applacation code should be as follows the form: 1.#include "system.h" 2int main(void) { int a = 0x12345678; int a_swap =0; a_swap= ALT_CT_BSWAP(a); return 0; } According to this kind of form,my custom instructiont mode in applacation code do not work ! I fined the Another example of User Guid is different from this form. ... alt_u8 zeros_hardware[NUM_SAMPLES]; alt_u32 numbers[NUM_SAMPLES]; ... void hardware_leading_zeros(void); compare_leading_zeros(void); ...# ifdef ALT_CT_LEADING_ZERO_DETECTOR hardware_leading_zeros(void); compare_leading_zeros(void);# endif ALT_CT_LEADING_ZERO_DETECTOR ...# ifdef ALT_CT_LEADING_ZERO_DETECTOR zeros_hardware = alt_ct_leading_zero_detector(numbers);# endif ALT_CT_LEADING_ZERO_DETECTOR ... When I put my custom instructiont mode into the leading-zeros-detector example running well ,my custom instructiont mode can work well! but when I put my custom instructiont mode into my system without sysid,it can not work again. why ?! whether the custom instructiont mode in applacation code want a limited_times sysid or other condition? thank you. http://forum.niosforum.com/work2/style_emoticons/<#EMO_DIR#>/rolleyes.gif sbgxg123_zhb@21cn.net zhgxg@163.netLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I don't see any reason why the SysID peripheral would have anything to do with it (I suggest you keep it in your design to make sure you are using the correct hardware). One thing to make sure of is that you have the correct name of the custom instruction (in your case " ALT_CT_BSWAP(a)"). If the C compile occured with no errors then this wouldn't be the cause.
Can you describe further what you are seeing and how you set up the custom instruction?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page