- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear :
i want to change the uart1's baud rate (altera cyclone board,default:115200. i want 9600), after i changed it, and download to the board . but when i start the uclinux , the ide shell cannot detect the cf card(cannot see "hitach ****").should i change some setting in my uclinux kernel? thanks!!!!Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am inclined to think this is a core problem. Can you access CF through Altera's standalone ide utilities?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i redo a new kernel , that's ok ,thank you !!!!!
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page