Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12615 Discussions

teraterm setting for sd card boot up. in cyclone 5

Altera_Forum
Honored Contributor II
1,672 Views

I 've just received my board, started to play with the SD card boot, the problem is when i use the teraterm with the setting mentioned, nothing printed out. but when i use the putty software and also same serial setting, it showed the log for the boot.. any one know what are the additional setting i nede to set in order to ues the teraterm connection?

0 Kudos
5 Replies
Altera_Forum
Honored Contributor II
571 Views

this should be same setting too... what is the problem you see in teraterm actually?

0 Kudos
Altera_Forum
Honored Contributor II
571 Views

nothing pop up from the black terminal screen, that's the problem.

0 Kudos
Altera_Forum
Honored Contributor II
571 Views

did you change your option to tera term VT, in good sign? otherwise you will not see some printing from the terminal...in new lines

0 Kudos
Altera_Forum
Honored Contributor II
571 Views

I will try this and let you know later. I feel using putty is easier.

0 Kudos
Altera_Forum
Honored Contributor II
571 Views

both should be working the same if the setting is correct...

0 Kudos
Reply