- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have problems to re-configure the data rate of transceiver receiver with altgxb_reconfig megafuntion. What I wanted to do exactly is a data rate switch using clock dividers (change receptor from 2 to 1 Gbyte)s . In the page 2-225/6 of the document Stratix II GX device handbook, volume 2, can find the steps to continuing, but I get lost in the 6th. Did someone may detail to me by little more which are the steps to following?
ThanksLink Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have done this on Stratix 4 Gx. 1) Instantiate ALTGX 2) Instantiate ALTGX_RECONFIG with data rate division option selected 3) Connect the two together 4) You dont need a mif file for this. Choose the correct mode for Stratix 4 its 011 and correct dividor (2'b01 in stratix 4) and just pulse write signal for one clock cycle -Akshay- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hallo,
and when do i need a .mif file? What can i change by reconfiguring Channel and TXPLL select (CMUPLL, Channel reconfig with TXPLL selcet, ...)? What does the CMUPLL do? Is it on the receiver side? regards
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page