C3508 Processor Bring-up Support

[pmswengr]

Hi Team, we are building a proto board with C3508 Processor. It looks like we would require Intel-ME and Intel-GBE binaries to be used by PCH to load into ME coprocessor and GBE controller during POR and SYS_RESET. Could you please correct or confirm our understanding, and help with the same? Also, any other dependencies?

[Diego_INTEL]

Hello @pmswengr,

Thank you for contacting Intel Embedded Community.

Denverton is not actively supported anymore but you can still apply for a Developer/Premier account in order to get access to the documentation.

https://www.intel.com/content/www/us/en/support/articles/000058073/programs/resource-and-documentation-center.html

I think you can try with document #559462 - SPI Programming Guide.

Best regards,

@Diego_INTEL

[pmswengr]

Dear Team,

Apologies for the delayed response.

It is from the Premier account support that I have been re-directed here. Not sure, if you can view the following: 
Support Request: 06753141 (link for me:  https://supporttickets.intel.com/s/requestdetail?id=500KZ00000FxVtMYAV)

Also, I am not able to find the document you advised, from my search results:  #559462 - SPI Programming Guide, in the Resource and Documentation Center.

Any kind of advice on the next steps would be extremely helpful.

Best Regards,

[Diego_INTEL]

Hello @pmswengr,

Yes, a Premier account is needed to get access to it, also, Denverton is not being actively supported anymore but I think if you need, the Premier account can be helpful to still get access to the documentation available. If you have any troubles you can consult to your FAE or an Intel Sales Representative near your zone.

Best regards,

@Diego_INTEL