- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
My name is Vitaliy.
For our new board we chose NHI350AM2 (2 copper ports)
There are some questions
1. Is there a reference design for NHI350AM2?
2. We want to use a built-in 1.8 / 1.0 converter, but in the section "3.5.2 1.0V SVR Control" the is not an example of the calculation of the nominal elements.
We have a X540 / I350-BT2 Reference Design, but there is not enough information for us
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
please refer to the following document http://www.intel.com/content/dam/www/public/us/en/documents/reference-guides/ethernet-controller-i350-reference-design.pdf I350 REFERENCE DESIGN.
Hope this helps,
Jimmy.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Vitaliy,
Welcome to the Intel Embedded Community,
We're working in your case, we will contact you as soon as possible with additional information.
Regards,
Jimmy.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
please refer to the following document http://www.intel.com/content/dam/www/public/us/en/documents/reference-guides/ethernet-controller-i350-reference-design.pdf I350 REFERENCE DESIGN.
Hope this helps,
Jimmy.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page