SR300 enclosure CAD model

[CFant]

Hi everyone,

I'm Claudio Fantacci, R&D engineer at the Humanoid Sensing and Perception (iCub Facility) of the Istituto Italiano di Tecnologia, Genoa, Italy.

We are investigating the use of the RealSense Cameras on our robotic platforms and we found the SR300 camera appealing for our needs.

Unfortunately, however, we miss a very important piece of information from the SR300 data sheet: either 1) the complete CAD of the enclosure or 2) the rigid transformation (roto-translations) from the tripod mount hole to the camera frames.

Is it possible to have such information/specifications?

I'm looking forward for further updates on the matter,

best regards

[CarlosAM_INTEL · Accepted solution]

Hello, Claudio:

Thank you for contacting Intel Embedded Community.

In order to help you, we suggest you address your Intel(R) RealSense(TM) Camera SR300 information requests and questions to the https://communities.intel.com/community/tech/realsense Intel® RealSense Community.

We hope that this information may help you.

Best regards,

Carlos_A.

[CFant]

Hi Carlos A,

thanks for reaching out.

I was suggested by Intel support to post here. Anyway, thanks for pointing me to te right direction.

Will re-post in the suggested community.