Use "lanconf64e.efi" to measure the X710 10G Fiber signal (TX/RX), but something goes error

[DavidCFWei]

Excuse me, I want to measure the X710-BM2 (IC) 10G Fiber signal (TX/RX) and use "lanconf64e.efi" tool to set the settings But there will be many situations:

Tx:

Only 10G_PRBS31 can be used for measurement. If you switch to other options (PRBS9/PRBS31/Square 8), the signal will disappear immediately.

Measuring DUT requires PRBS9 & Square 8 for measurement.

RX:

Unable to find suitable instructions for measurement (EX: DUT Loopback or read PRBS BER)

You can only see the BASE-T option in IEEE BER Test

Use BERT (test instrument) to drive the PRBS signal into the RX of the chip through the test fixture

And

We also encountered the same situation when measuring E810-XXVAM2 25G Fiber.

Any suggestions or a better testing tool?

[Sazirah]

Hi DavidCFWei,

Thank you for posting in Intel Ethernet Communities.

Regarding your enquiries, please give us some time as we are currently checking on this and we will get back to you from time to time.

Regards,

Sazzy_Intel

[Sazirah]

Hi DavidCFWei,

Regarding this enquiries, we have dedicated expertise team that can assist you.

Please reach out to Intel Developer Zone : https://www.intel.com/content/www/us/en/developer/overview.html#gs.isnfp5 or open IPS case.

Please refer the link below on how to reach the IPS support

How to Register and have Access to Intel® Premier Support

Therefore, we will be closing this forum thread at our end since you will be contacting them.

Regards,

Sazzy_Intel

Regards,

Sazzy_Intel