FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
5283 Discussions

In my design i am using the cyclone device with the manufacturer partnumber "EP3C55F484I7NGA". We are sending some single ended signals with 1.8V. But i have doubt that whether the device has capability of LVCMOS mode of logic?

VKuma63
Beginner
442 Views
 
0 Kudos
4 Replies
YuanLi_S_Intel
Employee
101 Views

Hi Vilas,

 

Why not? LVCMOS is available in Cyclone III.

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyc3/cyc3_ciii52001.pdf (Page 10)

 

Regards,

YL

VKuma63
Beginner
101 Views

Hello Sooyl,

 

Thanks! for your info.

 

I have referred the datasheet earlier itself it states clearly, there will be option for LVTTL/LVCMOS 1.8 V in page No 10.

 

But i have to do Signal integrity analysis for the same signals using the Cyclone3 IBIS models. In that LVCMOS 1.8V model selector was not available. Only LVTTL models are present.I got confused over here.

 

So, what can be considered for SI simulations. kindly provide your suggestion.

 

Regards,

Vilas Kumar S

YuanLi_S_Intel
Employee
101 Views

Hi Vilas Kumar,

 

Sorry for confusing, LVTTL / LVCMOS 1.8V share the same I/O behavior. Thus, you may use LVTTL 1.8V for LVCMOS 1.8V for SI simulation.

 

Regards,

YL

VKuma63
Beginner
101 Views

Thanks

 

Regards,

Vilas Kumar S

Reply