Graphics
Intel® graphics drivers and software, compatibility, troubleshooting, performance, and optimization
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
22768 Discussions

ICH9M - AHCI or IRRT on Dell M4400

idata
Employee
‎04-06-2010 08:45 AM
2,882 Views

Setup as AHCI the hard drive controller is under IDE ATA/ATAPI controllers and is shown as a IDE device in System Information. If I set it up as IRRT the hard drive controller is under Storage Devices and System Information shws it as a SCSI device. The both are using IRQ 19, but I was curious if there was a perfomance difference in the two different setups. I'm asking this from a pure technical standpoint as I'm there is some software that I could use to test it and I probably will if I can find this type of software. Thanks!!

0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.