Graphics
Intel® graphics drivers and software, compatibility, troubleshooting, performance, and optimization
22972 Discussions

SSD Trim Issue - New toolbox says RAID... when no RAID ?!

idata
Employee
‎01-22-2010 10:49 AM
1,532 Views

Updated Firmware with no problem (on W7 64bit machine); Only one 80Gig 25 series in rev 2 SSD drive (never in RAID); BIOS set to IDE (AHCI causes machine to bluescreen). Launch TRIM toolbox to optimize and it immediately returns a "cannot optimize a RAID disk"... which I know and which it isn't (RAID). What gives?

0 Kudos

Link Copied

1 Reply
idata
Employee
‎07-02-2010 12:40 PM
718 Views

Did you sort this.

On my setup which is not raid about half the time I get the same arror,but can optimise normally the other 50% of time. Once this starts to happen it will continue until I rebbot. Then there is a 50% chance that the optimiser will worl normally.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.