- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
I am trying to program Cyclone two. One of my input pin is three bit input2..0] but when I try to assign it physically to a pin in the chip, the quartus sees it as three indivitual inputs not as one three bit input pin. Any idea how to do it ??? regards khisrowLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
just assign the desired pin number to each individual bit of your 3-bit bus. it will still behave like a bus in your logic and you route it how ever you'd like on your board.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page