- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I've recently inherited a Nios dev board, with an APEX EP20k200EFC484-2X FPGA, have downloaded Quartus II package, and can configue the device with an image. I want to know how to store an image to the board, so that I don't need to load it each time I power-up?
I got the board with no software or docs and have no knowledge of what Nios design it might have contained. However, from the Nios Embedded Processor Development Board Data Sheet I have tracked down it looks like I might need to do something with the pre-loaded Nios design to store my image to memory on the board. Does anyone have any suggestions as to how I might proceed? Many thanks, JamesLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I've realised that Nios II is not compatible with my (old) hardware anyway, and Nios I is not supported by the tools/available, so cannot hope to use this anyway.
Does anyone know if it is possible to configure the FPGA/board once rather than on every power up with these constraints? Many thanks, James
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page