- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
at the beginning ,i'm running Archer City normally,everything is ok, I can see the BIOS interface by clik deltete key.
i don't know if i changed something, it can't show the BIOS interface anymore.
but OS can start normally.
I found there is a err log at the bios stage which did not exist earlier.
you can see the err log through the attachment .
can you give me a hand?
Thanks
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
further more,i did work on the jumper.
short J5C4 to BIOS recover mode, no change.
short J2A1 to clear CMOS, no change.
what's the problem behind it?
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Arthur78,
Thank you for contacting Intel.
We appreciate you reaching out to us regarding the reported issue.
To address your recent question, we highly recommend you contact our Field Application Engineer (FAE) for specialized assistance. Alternatively, you can open a new ticket through the Intel® Software Development Platform (Intel® SDP): http://www.intel.com/sdp for further support.
Thus, we will proceed to close this thread.
Regards,
Fikri O.

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page