Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20705 Discussions

All outputs set to high with basic and/or project

Altera_Forum
Honored Contributor II
‎08-15-2014 09:17 PM
824 Views

I just got the Cyclone II mini board listed here: http://www.amazon.com/riorand-ep2c5t144-altera-cyclone-development/dp/b00lemkr92, and I am trying to make a basic project that does a ternary "and" and 'or" operation on the three inputs. However, when I upload it, all the two output pins and the three onboard LEDs are always set to high. Does anyone know why this might be? Here is the Quartus II project: https://www.dropbox.com/s/ul3t8gm6gcyf7vq/basiclogic.zip

0 Kudos

Link Copied

0 Replies
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.