Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
21615 Discussions

About Altera Cyclone V E FPGA Development Board

Altera_Forum
Honored Contributor II
‎08-16-2014 03:41 AM
1,125 Views

I have some question about it. 

In the cyclone v e fpga development board reference manual(pdf) (http://www.altera.com/literature/manual/rm_cve_fpga_dev_board.pdf) , it mentions "16-channel differential 24-bit ADC" on board reference U35, but I don't see U35 on Figure 2–1. 

Q1: It means 16-channel differential 24-bit ADC is on this board or needing to addition it by myself? 

 

We want to use this board to control moter. 

In this paper: http://www.altera.com/literature/wp/wp-01162-motor-control-toolflow.pdf 

"Figure 3. FOC Model" shows that PWM output to motor. 

Q2: How can I use the FPGA fabric to complete PWM? 

 

Thanks for your answer!
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.