- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Am new to the Gen 2 and therefore follow the steps for Galilep Gen 2 in :
https://software.intel.com/en-us/iot/library/galileo-getting-started
The firmware is upgraded successfully and the arduino is also installed. The Galileo is also recognised by my Windows computer.
When I run the code in Arduino the upload goes fine but the the onboard LED does not blink.
Can I be guided on what I miss here?
Thanks
Rama
- Tags:
- Internet of Things
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
From the screenshot I see that you selected Galileo as board. If you are using Gen 2 board you may need to select Galileo Gen 2. Please download the latest Intel Ardiuno 1.6.0 which should enable all the three options Edison, Galileo and Galileo Gen 2.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page