Enabling Profiler

[Intel_C_Intel]

The documentation give the following instructions to use profiling:

1 In the Project menu, select Settings.
2 Click the Link tab.
3 In the General category, click the Enable profiling checkbox (this turns off incremental linking).
4 In the General category, click the Generate mapfile checkbox.
5 Click OK to accept the current project settings.
6 Build your application.
7 After building your application, profile your project.

My problem is the Enable profiling checkbox is not active. Is there some other setting that inactivates it?

I also see an earlier posting on the forum that implies only one subroutine per file is included in the profiling. Is this right?

[Steven_L_Intel1]

See if this knowledge base article helps at all.

The issue with the subroutines is that if you have multiple subroutines in a source file, the profiler will assign all the time in any subroutine to the first one. This has us truly baffled, and we hope to figure it out someday...

Steve