Software Tuning, Performance Optimization & Platform Monitoring
Discussion around monitoring and software tuning methodologies, Performance Monitoring Unit (PMU) of Intel microprocessors, and platform monitoring
Welcome to the Intel Community. If you get an answer you like, please mark it as an Accepted Solution to help others. Thank you!

Startup of the UMDF reflector


in the event viewer I get this information message first:


UMDF reflector is unable to connect to service control manager (SCM). This is expected during boot, when SCM has not started yet. Will retry when it starts(Event ID: 10118)


and immediately after that, warning: 


The driver \Driver\WudfRd failed to load for the device PCI\VEN_8086&DEV_318C&SUBSYS_72708086&REV_06\3&11583659&0&01.(Event ID: 219)

Management Engine Interface (Intel MEI).



any ideas how should i start the driver at boot time?

0 Kudos
0 Replies