- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I'm designing a board that will have a Xilinx Virtex5 and an Altera CycloneII FPGA on there, and I was wondering if there exists a solution where I can use just one Flash device for both FPGAs. Thanks for any insight.Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can add a PLD on you board with will program's the fpga's. For example first the CycloneII and then the Virtex5.
Or you can use one of the FPGA to configure the other one. Example the Virtex5 is configured form the flash first. The Virtex5 reads some other part of the flash chip and configures the CycloneII.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page