- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I recently tried to shift to V9.1 in the middle of a big project with mild results. I should not tried ... I would like now to work with NIOS II IDE and Quartus II V9.1 (I Need V9.1 for some max_skew optimisation in the project) so far and shift to EDS later on. NIOS II IDE is described as legacy. Is there any V9.1 release for it and did you find where it is located ? Or do I need to keep NIOS II IDE V9.0 SP2 ? Has anybody expereince with that (Usoing Quartus V9.1 and an older release of IDE) ? With thanxs and regards, ThierryLink Copied
4 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The NIOS II 9.1 IDE is in the Start-menu under Altera / NIOS II EDS 9.1 / Legacy NIOS II Tools / NIOS II 9.1 IDE
Or directly C:\Altera\91\nios2eds\bin\eclipse\nios2-ide.exe Note that 9.1 tools suffer a bug related to EPCS programming. So if your design uses EPCS flash, make sure you first test programming the EPCS flash and make sure your board can load the FPGA code and application before you jump into 9.1 completely ... Jari- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you elaborate on the 9.1 epcs bug?
Also I have problems with the new IDE finding header files that are in sub directories. If they are in the root of the project they are found ok. Makes debuging inline functions and template functions hard. jcn- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- Can you elaborate on the 9.1 epcs bug? jcn --- Quote End --- See "epcs booting problem" thread ( http://www.alteraforum.com/forum/showthread.php?t=19496 ). Jari
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- The NIOS II 9.1 IDE is in the Start-menu under Altera / NIOS II EDS 9.1 / Legacy NIOS II Tools / NIOS II 9.1 IDE Or directly C:\Altera\91\nios2eds\bin\eclipse\nios2-ide.exe Note that 9.1 tools suffer a bug related to EPCS programming. So if your design uses EPCS flash, make sure you first test programming the EPCS flash and make sure your board can load the FPGA code and application before you jump into 9.1 completely ... Jari --- Quote End --- Thanxs a lot Jari. I'm stupid ... Rgds, Thierry
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page