Embedded Connectivity
Intel network controllers, Firmware, and drivers support systems
879 Discussions

Programming MAC Address (on I210) into the flash chip using EepromAccessTool when I have multiple NI

JyothiAS
Beginner
935 Views

I have multiple NIC chips to be programmed with unique MAC address. Can I do this with EepromAccessTool.
If yes, then what are the parameters I need to configure and how can I do?
If No, is there any change I can do with the script or do we any other tool for this purpose.

0 Kudos
2 Replies
Fariz_Intel
Employee
775 Views

Hi JyothiAS.


We sincerely apologize for the late response and any inconvenience it may have caused.


We have a forum for those specific issues and you are moving it to that Embedded community to reach the proper support.


You may refer document below for more information.

https://cdrdv2-public.intel.com/334026/ethernet-controller-i210-i211-faq.pdf


Best regards,

Fariz_Intel


0 Kudos
Diego_INTEL
Moderator
679 Views

Hello  @JyothiAS,

 

Thank you for contacting Intel Embedded Community.

 

Yes, you can do it, you will need the iNVM image and the EEPROM Access Tool. You can check the following documents:

 

#572162 - EEPROM Access Tool [EAT].

#513655 - Intel® Ethernet Controller I210 and I211- AT Production NVM Images

 

The document #572162 includes a user guide, you may check section 4.0 - Using the Tool.

"Users can also program the device together with a MAC address".

 

Also, you may find all documentation available for the i210 using this link:

https://www.intel.com/content/www/us/en/products/details/ethernet/gigabit-network-adapters/i210-server-adapters/docs.html

 

Is required a Premier account in order to get access to the mentioned documents.

https://www.intel.com/content/www/us/en/support/articles/000058073/programs/resource-and-documentation-center.html

 

Best regards,

 

@Diego_INTEL 

0 Kudos
Reply