Programming MAC Address (on I210) into the flash chip using EepromAccessTool when I have multiple NI

[JyothiAS]

I have multiple NIC chips to be programmed with unique MAC address. Can I do this with EepromAccessTool.
If yes, then what are the parameters I need to configure and how can I do?
If No, is there any change I can do with the script or do we any other tool for this purpose.

[Fariz_Intel]

Hi JyothiAS.

We sincerely apologize for the late response and any inconvenience it may have caused.

We have a forum for those specific issues and you are moving it to that Embedded community to reach the proper support.

You may refer document below for more information.

https://cdrdv2-public.intel.com/334026/ethernet-controller-i210-i211-faq.pdf

Best regards,

Fariz_Intel

[Diego_INTEL]

Hello  @JyothiAS,

Thank you for contacting Intel Embedded Community.

Yes, you can do it, you will need the iNVM image and the EEPROM Access Tool. You can check the following documents:

#572162 - EEPROM Access Tool [EAT].

#513655 - Intel® Ethernet Controller I210 and I211- AT Production NVM Images

The document #572162 includes a user guide, you may check section 4.0 - Using the Tool.

"Users can also program the device together with a MAC address".

Also, you may find all documentation available for the i210 using this link:

https://www.intel.com/content/www/us/en/products/details/ethernet/gigabit-network-adapters/i210-server-adapters/docs.html

Is required a Premier account in order to get access to the mentioned documents.

https://www.intel.com/content/www/us/en/support/articles/000058073/programs/resource-and-documentation-center.html

Best regards,

@Diego_INTEL