Embedded Connectivity
Intel network controllers, Firmware and drivers.
Announcements
This community is designed for sharing of public information. Please do not share Intel or third-party confidential information here.
633 Discussions

Programming a blank Flash i225

Marco000
Beginner
434 Views

Hello,

 

I´m into designing a NIC with the I225-V. While designing it I was following your design considerations. As a Flash i have used the recommended W25Q16JVSNIQ from Winbond. Now I want to setup my board. I tried to programm the flash via bootutil but it hasn´t worked. It says the device is unsupported. 

 

Can you please help me out if I have to do anything in advance?

 

Best regards

Marco

0 Kudos
1 Solution
CarlosAM_INTEL
Moderator
393 Views

Hello, @Marco000:

Thank you for contacting Intel Embedded Community.

We sent an email to the address related to this account with information that may help you.

Best regards,

@CarlosAM_INTEL

View solution in original post

2 Replies
Mike_Intel
Moderator
412 Views

Hello Marco000,


Thank you for posting in Intel Ethernet Communities. 


Base on your inquiry, we have specific forum for these issues and I will be transferring this thread for faster response. 


Please wait for their reply within 1 to 2 business days.


Thank you.


Best regards,

Michael L.

Intel® Customer Support Technician


CarlosAM_INTEL
Moderator
394 Views

Hello, @Marco000:

Thank you for contacting Intel Embedded Community.

We sent an email to the address related to this account with information that may help you.

Best regards,

@CarlosAM_INTEL

Reply