Embedded Connectivity
Intel network controllers, Firmware, and drivers support systems
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
914 Discussions

XL710's rate only reach 2.8Gbps

Xiande
Beginner
‎09-10-2025 11:56 PM
701 Views

Hi,

I I designed the PCB board,used XCZU19EG and FTXL710-AM, XCZU19EG PS connected to FTXL710-AM by PCIE 2.0 x4,below is the function block.2.png

1.PNG

The firmware is XL710_X710_7p20_SFI_Backplane_MCTP_CFGID7p2_Quad.

 

By the way, the FPGA XCZU19EG contains a A53 ARM core, the CPU frequency is only 1.2Gbps.

 

System is linux-5.15.

 

when the Board came back,I tested it by iperf tool, and found that the rate can only reach 2.8Gbps. In my project, I only need one 10Gbps, so could anyone help me analysis the reason ? and how can I improve the rate ?

 

Thanks!

0 Kudos

Link Copied

1 Reply
Diego_INTEL
Moderator
‎09-18-2025 02:09 PM
292 Views

Hello @Xiande,

 

Thank you for contacting Intel Embedded Community.

 

All ethernet related forums should be handled by the Ethernet community but I will investigate this further and let you know if I find something that may be of help.

 

Best regards,

 

@Diego_INTEL 

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.