- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have decided to start supporting the FSP for our BIOS as it will allow us to adopt it faster to new architectures.
I have some questions though.
The FSP used for the project requires BCT 3.2 or later. It installs for Windows XP, but doesn't execute. Will in be fixed or do I need to install Windows 7 - 10 in my virtual environment for development?
Where can I find the rebase tool?
As I have not worked with BIOS adoptions for Intel architecture since 2016, I'm a bit rusty. Do you still use the same flash organisation with TXE partition occupying lower part?
Best regards,
B-O Bergman
PQURE Technology
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, @B-OatPQURE:
Thank you for contacting Intel Embedded Community.
Your Intel® Firmware Support Package (Intel® FSP) consultations should be addressed as a reference to the channel stated in the following website:
https://github.com/intel/FSP/issues
Best regards,
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, @B-OatPQURE:
Thank you for contacting Intel Embedded Community.
Your Intel® Firmware Support Package (Intel® FSP) consultations should be addressed as a reference to the channel stated in the following website:
https://github.com/intel/FSP/issues
Best regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page