Embedded Intel Atom® Processors
Technological Conversations about Intel Atom® Hardware, Software, Firmware, Graphics
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
1225 Discussions

How add GPO,Interrupts and I2c informations on ATOM.How to pass gpio pin numbers information to the driver.

vvard1
Beginner
2,797 Views

I have downloaded tianocore/edk2 and builded firmware image and flashed into Minnowboard and I am using 4.15.18 Stable kernel.Here My doubt is how to access/map (enable/disable) GPIO,Interrupt and I2c.Through Platform data or ACPI(.asl at kernel(.aml)) or we need to change at UEFI.Please explain how to do this one and please give examples.

0 Kudos
2 Replies
CarlosAM_INTEL
Moderator
1,878 Views

​Hello, @vvard1​ :

 

Thank you for contacting Intel Embedded Community.

 

We suggest you address your consultations related to mentioned devices and the firmware to the following channels as a reference:

 

https://github.com/tianocore/tianocore.github.io/wiki/Reporting-Issues

https://minnowboard.org/support

 

We hope that this information may help you.

 

Best regards,

@CAgui2​ . 

0 Kudos
vvard1
Beginner
1,878 Views

I Didn't get any related support.Please help me out.

0 Kudos
Reply