Embedded Intel Atom® Processors
Technological Conversations about Intel Atom® Hardware, Software, Firmware, Graphics

Intel Gordon Ridge Apollo Lake

SAdir
Beginner
6,011 Views

How to boot into ABL (ABL prompt)? After flashing linux (Yocto Build) the board does an auto-boot. But right now, trying some development work with it, need to login to ABL prompt. Tried setting DIP switch 1 to off and boot. But not working. Please help.

0 Kudos
5 Replies
CarlosAM_INTEL
Moderator
2,741 Views

Hello, sriniadiraju:

Thank you for contacting Intel Embedded Community.

The information that may help you is stated in section 3.7, specifically in the first note of the third step, on page 19 of the https://cdrd.intel.com/v1/dl/getContent/567191 Gordon Ridge Modular Reference Board (MRB) Getting Started Guide document # 567191.

This document is accessible to you using the Resource & Design Center (RDC) privileged account.

In case that you want an RDC account, please request it by filling out the https://www-ssl.intel.com/content/www/us/en/forms/design/contact-support.html Resource & Design Center Account Support form.

We hope that this information may help you.

Best regards,

Carlos_A.

0 Kudos
SAdir
Beginner
2,741 Views

Hi Carlos_A

I've read the document, but it does'nt say anything about working with ABL moreover the document does'nt contain a section 3.7.

I've crossed the first hurdle though, but right now having some issues with flashing images from SD-card specifically getting this error

abl-APL: rel.1721

CPU: APL-D0 [4C @ 1900MHz: premium SKU], ucode rev.24; power-on reset

CSE: FW 3.0.20.1182, SB: OFF

CSE: boot dev # 2: SPI

IPC config: R.<28 bytes> (11ms)

PCB # B00F: GR MRB (BMP fab.E, 4x16Gb); BM:1400

MRC: [v0.56.35/89.18] FB OK(0): 8GB

CSE: send DID UMA @10000000, 34MB

>>> boot sdc1:/abl64

SD: 0G, boot 0/0 [? SDR25 FW 0.0 56 5/16]: *** load err # -3

command failed(-9)

>>>

Could you help on this?

0 Kudos
CarlosAM_INTEL
Moderator
2,741 Views

Hello, sriniadiraju:

Thanks for your reply.

We suggest you review as a reference the information stated in section 4.5, on pages 22, 23, and 24 of the https://cdrd.intel.com/v1/dl/getContent/572371 Gordon Peak Automotive Boot Loader (ABL) Configuration Guide document # 572371.

We hope that this information will be useful to you.

Best regards,

Carlos_A.

0 Kudos
SAdir
Beginner
2,741 Views

Hi Carlos_A

Thanks for the document. But this document does'nt describe any error codes. The log, that I've posted above has some error codes explanation to those would help me debug.

Could you help in understanding the error codes?

0 Kudos
CarlosAM_INTEL
Moderator
2,741 Views

Hello, sriniadiraju:

Thanks for your update.

We suggest you address your consultations stated in your last communication to the Evaluation Kit mailto:click.support@intel.com Contact Customer Support email address.

We hope that this information may help you to solve this inconvenience.

Best regards,

Carlos_A.

0 Kudos
Reply