JHL8540 S RH4Q Schematic and Datasheet

[MATRIX7878]

Hello,

      I am not sure what the appropriate location to post this is, but this category makes the most sense.  I am creating a FPGA and want to include the JHL8540 S RH4Q (Thunderbolt 4) as a way to program the FPGA.  I cannot find a model for footprint, nor schematic.  Where can I find models so I can upload them to Altium and finish my design?  Or at the very least have a datasheet that has the dimensions so a schematic, pinout, footprint and 3D model can be made.

Thank you,

Drew

[Diego_INTEL]

Hello @MATRIX7878,

Thank you for contacting Intel Embedded Community.

You may check the document #614469 - Thunderbolt Maple Ridge DP Collateral -rev1.1-3 in RDC.

It contains everything related to design with this controller.

Best regards,

@Diego_INTEL 

[MATRIX7878]

Hello,

     I tried to find that document, but no results were found.  Could you please post the link?

Thank you,

Drew

[MATRIX7878]

Hello,

     It has been a while since I heard from you.  Is there any update for me?

Thank you,

Drew

[Diego_INTEL · Accepted solution]

Hello @MATRIX7878,

Oh, my apologies, thank you for reminding me, I had it pending but I forgot to answer.

Here, you can check the document I have mentioned:

https://rdc.intel.com/

But, it is required a Premier account to get access to that document, you can check this link:

https://www.intel.com/content/www/us/en/support/articles/000058073/programs/resource-and-documentation-center.html

Best regards,

@Diego_INTEL 

[MATRIX7878]

Hello,

     Thank you for responding.  I will try to get a Premier account so I can continue to build my board.

Thank you,

Drew

[Diego_INTEL]

Hello @MATRIX7878,

You are very welcome.

Best regards,

@Diego_INTEL